Below is a summary of the key information for your headlamp. You can download the full manual at the bottom of this page for more details.
8548-DH400 Headlamp Manual Breakdown
1. Key Features
-
Brightness Modes:
- High Mode: 400 lumens, 2 hours runtime, 70 meters beam distance.
- Low Mode: 250 lumens, 3 hours runtime, 40 meters beam distance.
-
Flood Lights (Side Lights):
- Features additional side flood lights for wider illumination.
-
Battery Type:
- Uses 3 AAA batteries (Duracell included).
-
Water Resistance:
- Rated IPX4, meaning it can withstand splashes but should not be submerged.
-
Adjustable Beam Angle:
- The headlamp can tilt to direct light where needed.
2. Operating Instructions
-
Turning On/Off:
- Press the power button once to turn the headlamp on or off.
-
Switching Modes:
- Quick press the power button to cycle through modes:
- High Mode โ Low Mode โ Flood Lights โ Off.
- Quick press the power button to cycle through modes:
-
Activating Flood Lights:
- Press the power button repeatedly until the side lights (flood lights) turn on.
-
Adjusting the Beam Angle:
- Manually tilt the headlamp for better light positioning.
3. Battery Information
-
Installation:
- Open the battery compartment by sliding the cover.
- Insert 3 AAA batteries with the correct polarity (+/-).
- Close the cover securely.
-
Battery Safety:
- Do not mix old and new batteries or different brands.
- Remove batteries if the headlamp will not be used for an extended period to prevent leakage or corrosion.
4. Safety Guidelines
- Avoid shining the light directly into eyes to prevent discomfort or temporary blindness.
- Keep the headlamp out of reach of children.
- Use only the recommended battery type to avoid damage.
5. Maintenance
- Clean the headlamp with a soft, damp cloth after use.
- Store in a cool, dry place when not in use.
- Avoid submerging the headlamp in water, as it is splash-resistant but not waterproof.
6. Troubleshooting
-
If the headlamp doesnโt turn on:
- Check the battery orientation (+/-).
- Replace the batteries if necessary.
- Clean the battery compartment to ensure proper contact.
-
If the flood lights donโt turn on:
- Ensure the batteries are fresh and installed correctly.
- Cycle through the modes using the power button.
Comments
0 comments
Article is closed for comments.